Sandvik Saf 2205™

saf 2205 stainless steel

The effect of deformation on the yield and tensile strength was expressed using a Hall-Petch kind relationship where the grain size was represented by the common width of the ferrite bands. The observed anisotropy in strength properties is believed to be due te texture hardening. Because elongation at a given energy level is similar in both the longitudinal and transverse directions, the banding itself doesn’t affect the ductility. Nor can the power anisotropy be because of banding, as a result of the power is bigger within the longitudinal than within the transverse direction. SAF 2205, also known as Sandvik SAF 2205, is a Sandvik-owned trademark for a 22Cr duplex (ferritic-austenitic) chrome steel.

Intergranular Corrosion


  • Sanmac®2205 is a 22% Cr duplex chrome steel with improved machinability as commonplace.
  • Laboratory outcomes for Sandvik SAF 2205™ of fixed load specimens loaded to the proof power on the check temperature.
  • The ferritic chromium steel ASTM 410 fails at significantly lower stress.
  • Resistance to stress corrosion cracking (SCC) in neutral chloride options with an oxygen content material of about 8 ppm.
  • The excessive resistance of Sandvik SAF 2205™ is proven within the determine by the fact that very high stresses, about 1.1 occasions the 0.2% proof strength, are required to induce stress corrosion cracking.

The main parameters used have been the chord dimension to characterize the ferrite section and Feret’s diameter for the austenite phase. As the deformation elevated, ferrite bands turned more elongated and thinner, contributing to a pronounced banding. The amount of banding can be quantified by using a ratio between the slopes of the chord measurement distributions within the longitudinal and quick transverse directions. According to a proposed mannequin of the affect of deformation on the 2-section construction, the method of austenite elongation and subdivision of austenite islands (crushing) is described.

They are delivered within the solution annealed condition and both white pickled or shiny annealed. They can also Stainless steel manufacturer be delivered chilly-worked without subsequent heat treatment.

The ranking given by the PRE number has been confirmed in laboratory exams. This ranking can typically be used to predict the performance of an alloy in chloride containing environments.

The nominal chemical composition of SAF 2205 is 22% chromium, 5% nickel, three.2% molybdenum and other alloying components corresponding to nitrogen and manganese. The UNS designation for SAF 2205 is S31803/S32205 and the EN steel no. is 1.4462. SAF 2205 or Duplex 2205 is usually used as an alternative to costly 904L stainless-steel owing to related properties however cheaper components. Duplex stainless steel is on the market in a number of varieties like bars, billets, pipes, tubes, sheets, plates and even processed to fittings and flanges. Seamless tube and pipe in Sandvik SAF 2205™ is supplied in dimensions as much as 260 mm (10.2 in.) outside diameter.

Because of the high Mo and N contents, the PRE number for Sandvik SAF 2205™ is significantly higher than what can be the case with lower Mo and N contents which are still inside the limits of UNS S31803. Corrosion price of SAF 2205™, ASTM TP316L and ASTM TP317L in boiling mixtures of 50% acetic acid and ranging proportions of formic acid. The bodily properties of grade 2205 stainless steels are tabulated beneath. The typical mechanical properties of grade 2205 stainless steels are listed within the desk under.